Mechanical Instructions
EN 23TPN10.1E LA 4.
2013-Oct-18
back to
div. table
Figure 4-13 Rear cover removal [2]
4.4.2 Speakers
Refer to Figure 4-10
and Figure 4-13 for details.
1. Remove fixation screws [1] that secure the speakers cover,
Refer to Figure 4-13
for details.
2. Gently lift the speakers cover from the TV. Make sure that
wires and cables are not damaged while lifting the rear
cover from the set.
3. Remove the fixation screws [1] that secure the speakers.
Refer to Figure 4-10
for details.
4. Gently take the cable [2] out from the snap. Then gently
unplug the connectors [3] from the SSB. Refer to
Figure 4-10
for details.
5. Gently take the speakers out.
When defective, replace the whole unit.
4.4.3 Small Signal Board (SSB)
Refer to Figure 4-14
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1. Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2].
3. Remove all the fixation screws from the SSB [3].
4. The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
Figure 4-14
for details.
Figure 4-14 SSB removal
4.4.4 Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1. Gently unplug all connectors from the PSU.
2. Remove all fixation screws from the PSU.
3. The PSU can be taken out of the set now.
19530_109_130723.eps
130723
Q3 × 8
1
1
1
19530_113_130724.eps
130724
2
1
3
3
3
3
To Next Page
Loading...
