English
12
These operations are accessible by remote control.
Some may also be accessible by control panel on the main unit.
Initial setup
This section will guide you through the unit’s initial setting which
includes selecting a language for your on-screen menu and autoprogram,
which automatically scans and memorizes viewable channels.
Before you begin:
Make sure the unit is connected to antenna or cable.
1 After making all the necessary connections, press to Turn On the
unit.
• It may take a few moments to Turn On the unit for the fi rst time.
• Initial setup menu appears automatically after the unit is Turned
On.
2 Use ▲▼ to select the on-screen language from the choices
(English / Español / Français) on the right side of the TV screen, then
press OK.
3 Use ▲▼ to select Antenna for TV channels or Cable for CATV
channels, then press OK.
Initial setup
Make sure the antenna is connected to ‘’ANTENNA IN’’ jack.
Select your signal source.
Antenna
Cable
Antenna
Cable
Or
ANTENNA IN
Skip
Select OK Back Skip
– When Antenna is selected, the TV detects antenna signals. It
searches for DTV and Analog TV channels available in your area.
– When Cable is selected, the TV detects signals supplied by cable. It
searches for DTV, Analog TV and Cable channels available in your
area.
• Autoprogram will begin.
Initial setup
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to
complete.
0%
Digital channels
0 ch
Analog channels
0 ch
Skip
4 Use ▲▼ to select the desired location setting, then press OK.
Home is ENERGY STAR
®
qualifi ed setting.
Initial setup
Location Home is recommended for normal home use
and is ENERGY STAR qualified.
In the Retail Store mode, all settings are fixed.
Retail
Home
Select OK
• Select Retail, the unit will be set up with predefi ned setting
for retail displays. In this setting, the power consumption may
possibly exceed the limited requirement of the ENERGY STAR
®
qualifi cation.
• Select Home, the unit is set to maximize the energy effi ciency
for home setting and it can be adjusted through a choice of
picture and sound quality according to your preference. Use this
setting to remove the E-sticker if visible from the display.
➠
p. 27
5 When you select Home, press OK to begin Settings assistant.
Settings assistant
Settings assistant helps you customize picture settings.
You will see a series of test pictures where the right side and
left side differ. Select the side that is most pleasing to you
with the Left/ Right keys.
Next Back Exit
6 Press
Í
or
Æ
3 times to select the side of the pictures that is the
most pleasing to you, then press OK.
Left side Right side
1/3 Select the picture setting that you prefer.
Select Next Back Exit
7 Press OK to fi nish Settings assistant.
Settings assistant
You have set up your viewing preferences.
Store Back Exit
• When the initial setup is completed, the lowest memorized
channel with the confi rmation message of the location setting
will be displayed on the TV screen.
• You must set Home in step 4. Otherwise, Picture and Sound
settings you adjusted will not be memorized after the unit goes
into Standby mode.
Continued on next page.
To Next Page
Loading...
