Philips 40PFL5708/F7 - Page 14

14
English
OK
Store
Settings assistant
Yo u have set up your viewing preferences.
Exit
MENU
BACK
Back
5
Use▲▼toselectAntennaforTVchannelsorCableforCATV
channels,thenpressOK.
Setup Wizard (3/6)
Please select TV RF tuning band
Antenna
Cable
Previous Cancel
Select
OK
OK
C
able
– WhenAntennaisselected,theTVdetectsantennasignals.Itsearches
forDTVandAnalogTVchannelsavailableinyourarea.
– WhenCableisselected,theTVdetectssignalssuppliedbycable.It
searchesforDTV,AnalogTVandCablechannelsavailableinyour
area.
• Autoprogramwillbegin.
Setup Wizard (4/6)
Please check that the RF cable is connected properly.
Previous Cancel
Scan time may take over 20 minutes.
START
S
TART
Select
OK
OK
Setup Wizard (5/6)
Searching. Please wait
Searching CH
Digital Channels Found
Analog Channels Found
Channel 33
5
1
50%
Exit
MENU
Setup Wizard (6/6)
Congratulations. TV Setup is done.
Exit
MENU
Note
• Ifyouarenotreceivingasignalfromyourcableservice,contacttheCableprovider.
• Ifyoupress duringAutoProgram,thissetupofTVchannelswillbecanceled.
• TheinitialAutoProgramfunctioncanbeexecutedforeitherAntennaorCableonly
once.Whenyouchangetheconnection(Antenna/Cable),setAutoprogramagain.
p. 21
After an initial setup is completed...
• Ifyouwanttoscanthechannelsautomaticallyagain.
Autoprogram p. 21
• Ifyouwanttochangetoanotherlanguage.
Language p. 22
• Ifyouwanttochangethelocationsetting.
Location p. 26
• Ifyouwanttorestorethepicturesetting.
Settings assistant p. 18