Philips 40PFL5708/F7 - Initial Setup Procedures; Base Attachment and Battery Installation

9
English
Attaching the base
Youmustattachthebasetotheunittohaveitasatabletopunit.
Besurethefrontandrearofthebasematchtheproperdirection.
ForlargescreenTVs,atleast2peoplearerequiredforthesesteps.
1
2
M4-10mm
5
3
M4-10mm(40'' /47'' /50'')
M4-16mm(32'' /39'')
Note
• Makesuretouseatablewhichcansupporttheweightofthisunitandislargerthanthis
unit.
• Makesurethetableisinastablelocation.
• Whenattachingthebase,ensurethatallscrewsaretightlyfastened.Ifthebaseisnot
properlyattached,itcouldcausetheunittofall,resultingininjuriesaswellasdamageto
theunit.
• Toremovethebasefromthisunit,unscrewthePhillipsheadscrewsinstep2.
Becarefulnottodropthebasewhenyouremoveit.
Installing the remote control batteries
1
Slidethebatterycoveroffthebackoftheremotecontrol.
2
Insertthe2suppliedbatteries(AAA,1.5V).Besurethe+and−
endsofthebatterieslineupwiththemarkingsinsidethecase.
3
Slidethecoverbackintoposition.
Note
• Removethebatteriesifnotusingtheremotecontrolforanextendedperiodoftime.