Mechanical Instructions
EN 15TPB1.2HU LA 4.
2011-Mar-11
Figure 4-10 Cable dressing (42" for H series)
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assembly/Panel Removal
Instructions below apply to the 42HFL5682H/F7, but will be
similar for other models.
4.3.1 Rear Cover
Refer to Figure 4-11
to Figure 4-13 for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove fixation screws [1] that secure the smart link
cover, then lift the smart link cover and pull out the TV
antenna connector from the main board.
Refer to Figure 4-11
to Figure 4-12 for details.
2. Remove fixation screws [1] that secure the base assy, pull
out the base assy from the set. Then remove the fixation
screws [1], [2], [3], [4], [5] that secure the rear cover. Refer
to Figure 4-13
for details.
3. Lift the rear cover from the TV. Make sure that wires and
flat foils are not damaged while lifting the rear cover from
the set.
Figure 4-11 Rear cover removal [1/3]
Figure 4-12 Rear cover removal [2/3]
18890_100_100915.eps
100915
1
8890_101_100915.eps
101014
1
1
18890_102_100915.eps
101015
Pull out
To Next Page
Loading...
