32
Step 3 Fine-tune analogue channels
1 Press .
2 Select [Setup] > [Channel settings] >
[Channel installation] > [Analogue:
manual install] > [Fine-tune], then press
OK.
3 Press
Rename channels
You can rename channels. The name appears
when you select the channel.
1 While you watch TV, press FIND.
» The channel matrix menu is displayed.
2 Select the channel to rename.
3 Press OPTIONS.
» The channel options menu appears.
4 Select [Rename channel], then press OK.
» A text input box appears.
5 Press to select each character,
then press OK.
6 When the name is complete, select
[Done], then press OK.
Tip
Press [Aa] to change an uppercase letter to a
lowercase letter and vice versa.
Manually install channels
This section describes how to search and store
analogue TV channels manually.
Step 1 Select your system
Note
Skip this step if your system settings are
correct.
1 Press .
2 Select [Setup] > [Channel settings] >
[Channel installation] > [Analogue:
Manual antenna installation] > [System],
then press OK.
3 Select the correct system for your
country or region, then press OK.
Step 2 Search and store new TV
channels
1 Press .
2 Select [Setup] > [Channel settings] >
[Channel installation] > [Analogue:
Manual antenna installation] > *[Find
channel], then press OK.
If you know the three-digit frequency
of the channel, enter it.
To search, select [Search], then press
OK.
3 When the channel is found, select
[Done], then press OK.
To store the channel as a new
number, select [Store as new
channel], then press OK.
To store the channel as the
previously selected channel, select
[Store current channel], then press
OK.
EN
To Next Page
Loading...
