English
11
Connecting to an stereo
system
Receiver has a PCM, Dolby Digital
or MPEG decoder
A
Select one of the video connections
(CVBS VIDEO IN or COMPONENT
VIDEO IN) depending on the options
available on your television.
B Connect the COAXIAL jack of the DVD
player to the corresponding Digital Audio
In jack on your receiver (cable not
supplied).
C Set the DVD player’s digital output to
PCM-Only or ALL depending on the
capabilities of your receiver (see page 30
{Digital Output}).
Tip:
– If the audio format of the Digital Output
does not match the capabilities of your
receiver, the receiver will produce a strong,
distorted sound or no sound at all.
Stereo system has right/ left Audio
In jacks
A
Select one of the video connections
(CVBS VIDEO IN or COMPONENT
VIDEO IN) depending on the options
available on your television.
B Use the audio cables (white/red) to
connect AUDIO OUT (L/R) jacks of the
DVD Player to the corresponding
AUDIO IN jacks on the stereo system
(cable supplied).
Connecting to a digital AV
receiver
Optional connections
TIPS: Before making or changing any connections, make sure that all the devices are disconnected
from the power outlet.
AUDIO OUT
DIGIT AL
OUT
TV OUT
COAXIAL
AUDIO
IN
ST ER EO
DIGITAL
COMPONENT VIDEO OUT
AUDIO
IN
DIGITAL
AV Receiver
AUDIO OUT
DIGIT
AL
OUT
TV OUT
COAXIAL
COMPONENT VIDEO OUT
01-39_xDV437_438_55_77_eng2.indd11 1101-39_xDV437_438_55_77_eng2.indd11 11 2007-01-03 11:20:50 AM2007-01-03 11:20:50 AM
To Next Page
Loading...
