Philips 55PFL5604 User Manual

Important safety instructions
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including ampliers) that produce heat.
Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not t into your outlet, consult an electrician for
replacement of the obsolete outlet.
Protect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
Only use attachments / accessories specied by
the manufacturer.
Use only with the cart, stand,
tripod, bracket, or table specied
by the manufacturer, or sold with
the apparatus. When a cart is
used, use caution when moving
the cart / apparatus combination
to avoid injury from tip-over.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1 1.
12.
Unplug this apparatus during lightning storms or
when unused for long periods of time.
Refer all servicing to qualied service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord
or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
13.
14.
Note to the CATV system installer:
This reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, species that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.
Example of antenna grounding as per NEC -
National Electric Code
ANTENNA LEAD IN WIRE
GROUND CLAMP
ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)
ELECTRIC SERVICE EQUIPMENT
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
POWER SERVICE GROUNDING
ELECTRODE SYSTEM (NEC ART 250,
PART H)
GROUND CLAMPS
Wall mount bracket kit
Brand Model # Screw dimension
55PFL5704/F7
55PFL5604/F7
50PFL5704/F7
50PFL5604/F7
SANUS F80b M6 x 1.378” (35mm)
43PFL5704/F7
43PFL5604/F7
SANUS SAN25BB M4 x 1.378” (35mm)
●
Your TV meets the VESA standard for wall mounting. Consult with
your local dealer for a wall mount bracket which is compatible with
your TV model.
●
The recommended wall mount bracket kit (sold separately) allows
the mounting of the TV on the wall.
●
For detailed information on installing the wall mount, refer to the
wall mount Instruction book.
●
Funai Corporation is not responsible for any damage to the
product or injury to yourself or others if you elect to install the TV
wall mount bracket or mount the TV onto the bracket.
●
The wall mount bracket must be installed by experts.
Funai Corporation is not liable for these types of accidents or
injuries noted below.
●
If installed onto a ceiling or slanted wall, the TV and wall mount
bracket may fall which could result in a severe injury.
●
Do not use screws that are longer or shorter than their specified
length. If screws too long are used this may cause mechanical or
electrical damage inside the TV set. If screws too short are used
this may cause the TV set to fall.
●
Do not fasten the screws by excessive force. This may damage the
product or cause the product to fall, leading to an injury.
●
For safety reasons use 2 people to mount the TV onto a wall
mounting bracket.
●
Do not mount the TV onto the wall mounting bracket while your
TV is plugged in or turned on. It may result in an electrical shock
injury.
When installing the unit on the wall, allow this much space.
Top
: 1 1.8 inches (30cm)
Left and right side
: 5.9 inches (15cm)
Bottom
: 3.9 inches (10cm)
4 .English

Philips 55PFL5604 Specifications

General

Screen shape	Flat
Response time	16 ms
Display diagonal	54.6 \
Display brightness	- cd/m²
Display technology	LED
Native aspect ratio	16:9
Supported video modes	480i, 480p, 720p, 1080i, 1080p, 2160p
Contrast ratio (typical)	1000:1
Display diagonal (metric)	139.7 cm
Screen format adjustments	4:3, 16:9
Supported graphics resolutions	640 x 480 (VGA), 720 x 480, 800 x 600 (SVGA), 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 768 (WXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 1680 x 1050 (WSXGA+), 1920 x 1080 (HD 1080), 3840 x 2160, 4096 x 2160
Motion interpolation technology	-
RMS rated power	20 W
Number of speakers	2
AC input voltage	120 V
AC input frequency	60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	135 W
Product color	Black
Panel mounting interface	300 x 300 mm
Wi-Fi standards	Wi-Fi 5 (802.11ac)
Bluetooth version	4.2
High Dynamic Range (HDR) technology	High Dynamic Range 10 (HDR10)
Operating system version	Oreo
Operating system installed	Android
3D	No
Quantity per pack	1 pc(s)
Network streaming services supported	Chromecast
Tuner type	Analog & digital
Supported TV bands	UHF, VHF
Analog signal format system	NTSC
Digital signal format system	ATSC
Audio (L/R) in	1
HDMI ports quantity	3
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	0
Consumer Electronics Control (CEC)	EasyLink
Operating temperature (T-T)	5 - 40 °C
Cables included	AC
Package depth	152.4 mm
Package width	1412.24 mm
Package height	810.26 mm
Package weight	15399.46 g

Weight and Dimensions

Depth (with stand)	223.52 mm
Height (with stand)	751.84 mm
Weight (with stand)	10500.66 g
Depth (without stand)	78.74 mm
Width (without stand)	1249.68 mm
Height (without stand)	723.9 mm
Weight (without stand)	10400.87 g