Philips 55PFL6158K/12 - User Manual

Published by PvH/EL 1402 TV Quality Printed in the Netherlands Subject to modification EN 3122 785 19374
2014-Jan-10
2014
©
TP Vision Netherlands B.V.
All rights reserved. Specifications are subject to change without notice. Trademarks are the
property of Koninklijke Philips Electronics N.V. or their respective owners.
TP Vision Netherlands B.V. reserves the right to change products at any time without being obliged to adjust
earlier supplies accordingly.
PHILIPS and the PHILIPS’ Shield Emblem are used under license from Koninklijke Philips Electronics N.V.
Colour Television Chassis
QFU1.2E
LA
Contents Page
1. Revision List 2
2. Technical Specs, Diversity, and Connections 2
3. Precautions, Notes, and Abbreviation List 7
4. Mechanical Instructions 11
5. Service Modes, Error Codes, and Fault Finding 20
6. Alignments 40
7. Circuit Descriptions 45
8. IC Data Sheets 47
9. Block Diagrams 49
10. Circuit Diagrams and PWB Layouts Drawing PWB
310431366124 SSB
59
99-100
310431366185 SSB 101
141-142
310431366186 SSB 143
183-184
C 310431366652 Amplifier panel 185
272217190763, 272217190764, 272217190766
Keyboard Control Module 187
282206502664, 282206502665, 820400159661
Wireless LAN USB module, light sensor, IR/LED195
282206502668, 282206502669 Wireless LAN USB
module, light sensor, IR/LED 195
272217190759, 272217190761 Sensor Module 202
310431366033 AmbiLight 203
310431366043 AmbiLight 205
310431366053 AmbiLight 207
310431366063 AmbiLight 209
310431366292 AmbiLight 213
310431366302 AmbiLight 215
310431366312 AmbiLight 217
310431366372 AmbiLight 219
11. Styling Sheets
6000 series 42"/47" 222
7000 series 42"/47" 223
8000 series 40"/46" 224
8000 Design series 46" 225
6000 series 55"/60" 226
7000 series 55" 227
8000 series 55" 228
8000 Design series 55" 229
8000 series 60" 230
9000 series 65" 231
9000 series 84" 232

Philips 55PFL6158K/12 Specifications

General

Brand	Philips
Model	55PFL6158K/12
Category	TV
Language	English

Summary

Technical Specs, Diversity, and Connections

2.1 Technical Specifications

Details on product information, getting started, manuals, FAQs, software & drivers.

2.3 Connections

Details on how to connect various components to the TV.

2.3.1 Connections

Detailed overview of the physical connections on the TV.

Precautions, Notes, and Abbreviation List

3.1 Safety Instructions

Essential safety regulations and precautions to follow during repair.

3.2 Warnings

Critical warnings related to product usage and repair.

Mechanical Instructions

4.3 Assy;Panel Removal

Steps for removing the assembly or panel.

4.4 Set Re-assembly

Instructions for re-assembling the TV set.

Service Modes, Error Codes, and Fault Finding

5.2 Service Modes

Overview of service modes like SDM, SAM, and CSM for technicians.

5.2.1 Service Default Mode (SDM)

Details on entering and exiting Service Default Mode for predefined settings.

5.2.2 Service Alignment Mode (SAM)

Information on Service Alignment Mode for adjusting product parameters.

5.2.3 Customer Service Mode (CSM)

Details on activating and using Customer Service Mode for diagnostics and support.

5.5 Error Codes

Explains the error code buffer, logging, and blinking LED procedures.

5.5.1 Introduction

Details how error codes are logged and managed in the buffer.

5.5.3 How to Clear the Error Buffer

Procedures for clearing the error buffer via SAM or other methods.

5.5.4 Error Buffer

Information on error detection mechanisms and how to handle errors.

5.6 The Blinking LED Procedure

Explains the procedure for interpreting front LED blinking for error diagnosis.

5.6.1 Introduction

Describes the division of blinking LED procedures into LAYER 1 and LAYER2 errors.

5.6.2 How to Activate

Instructions on activating the blinking LED procedure via CSM or SDM.

5.7 Protections

Discusses software protections and related fault conditions.

5.7.1 Software Protections

Details various types of software-related protections and fault conditions.

5.8 Fault Finding and Repair Tips

Tips and guidelines for fault finding and repair.

5.8.2 CSM

Explains how to activate and use the Customer Service Mode for diagnostics and support.

5.8.3 Power conversion and distribution.

Details the power supply architecture, voltage distribution, and protection circuits.

5.8.7 Guidelines Uart logging

Guidelines on how to perform and interpret UART logging for diagnosis.

5.8.8 Memory test

Details on how to run the memory test and interpret its results.

5.8.10 Power Supply

Recommendations for checking LED drivers on PSL(S) in case of no picture.

5.8.11 Display option code

Importance of checking display option codes after SSB replacement.

5.8.12 SSB Replacement

Instructions and table for exchanging an SSB.

5.9 Software Upgrading

Instructions on how to upgrade the TV's software and firmware.

5.9.3 Standby Software Upgrade via USB

Steps for upgrading the Standby software using a USB stick.

Alignments

6.1 General Alignment Conditions

Conditions to perform electrical adjustments, including power supply and warm-up time.

6.3 Software Alignments

Steps for software-based picture alignments like White Point.

6.3.1 White Point

Procedure for aligning the White Point of LCD screens, with specific settings.

6.4 Option Settings

How the microprocessor communicates with ICs and knows which ones to address.

6.4.1 Introduction

Explains the microprocessor's communication with I2C ICs.

6.5 Reset of Repaired SSB

Important steps for resetting the NVM on a repaired SSB.

6.6 Total Overview SAM modes

Circuit Descriptions

7.1 Introduction

7.2 Power Supply

Information about the power supply unit and replacement of defective boards.

7.2.1 Power Supply Unit

Details about the power supply unit as a black box for service.

7.3 General Power Architecture

Circuit Diagrams and PWB Layouts

10.1 310431366124 SSB

10-1-2 B01 B, Fusion supply

10-1-10 B03 A, Fusion

10-1-11 B03 B, Fusion Umac controller

10-1-14 B03 E, Fusion

10-1-15 B03 F, Fusion power supply

10-1-16 B04 A, Control

10-1-21 B04 F, Fusion supply

10-1-22 B04 G, Backlight microcontroller

10-1-24 B05 A, Class-D amplifier

10-1-26 B05 C, Sensor board and AmbiLight

10-1-27 B06 A, HDMI

10-1-28 B06 B, HDMI-ARC

10-1-30 B06 D, Ethernet

10-1-33 B06 G, DC-DC

10-1-37 B06 K, HDMI

10-1-38 B06 L, Control, temperature sensor and service