Mechanical Instructions
EN 10 TPS15.3A LA4.
2015-Oct-23
back to
div.table
Figure 4-2 Cable dressing (55" 6600 series)
4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assembly/Panel Removal
Instructions below apply to the 49PUH6600/96, but will be
similar for 55" model.
4.3.1 Rear Cover
Refer to Figure 4-3
for details.
Warning: Disconnect the mains power cord before removing
the rear cover.
1. Remove the fixation screws [1] that secure the base assy,
pull out the base assy from the set. Then remove the
fixation screws [2],[3] that secure the rear cover. Refer to
Figure 4-3
for details.
2. Gently lift the rear cover from the TV. Make sure that wires
and cables are not damaged while lifting the rear cover
from the set.
19980_101.eps
CN701
CN8101
CN9101
CN403
MAIN POWER SUPPLY
(1054)
A
SSB
(1053)
B
ECN401A
ECN601
ECN403
ECN601
LOUDSPEAKER
(1184)
LOUDSPEAKER
(1184)
IR/LED BOARD
(1056)
J
ECN403
ECN701
E
CN01
KEYBOARD CONTROL
(1057)
CN103
CN601
ECN401A
ECN401A
ECN701
ECN601
CN401
WIFI MODULE
W
WiFi01
ECN103
ECN103
Tuner Board
(1067)
TU01
To Next Page
Loading...
Need help?
General