Philips 55PUS6262/12 User Manual

5. Upgrade in progress
Step 3: Check the SW version
1. After burning software, TV will restart
2. Press “Menu+1999+back”, enter Factory mode to check if the software version is correct
Caution: Please make sure that software upgrade is finished before unplug the USB and AC power!
5.2 Error Code
5.2.1 Introduction
Error codes are required to indicate failures in the TV set. In principle a unique error code is available for every:
• Activated (SW) protection.
• Failing I2C device.
• General I2C error.
The last five errors, stored in the NVM, are shown in the Service menu’s. This is called the error buffer.
The error code buffer contains all errors detected since the last time the buffer was erased. The buffer is written from left to right. When an error occurs that
is not yet in the error code buffer, it is displayed at the left side and all other errors shift one position to the right.
An error will be added to the buffer if this error differs from any error in the buffer. The last found error is displayed on the left.
An error with a designated error code never leads to a deadlock situation. It must always be diagnosable (e.g. error buffer via OSD or blinking LED).
In case a failure identified by an error code automatically results in other error codes (cause and effect), only the error code of the MAIN failure is displayed.

Philips 55PUS6262/12 Specifications

General

Screen Size	55 inches
Display Technology	LED
Smart TV	Yes
HDR	Yes
Ambilight	Yes
HDMI Ports	3
USB Ports	2
Screen Shape	Flat
Aspect Ratio	16:9
Internet TV	Yes
Operating System	SAPHI
Refresh Rate	60 Hz
Wi-Fi	Yes
Bluetooth	No
Sound Output	20 W
Component Video (YPbPr/YCbCr) In	1
Digital Audio Optical Out	1
Headphone Outputs	1
Common Interface (CI)	Yes
Common Interface Plus (CI+)	Yes
VESA Mounting	Yes
VESA Mounting Interfaces	200 x 200 mm
Product Colour	Silver
Resolution	3840 x 2160 pixels
Motion Interpolation Technology	PMR (Perfect Motion Rate)
HDR Formats	HDR10
HDMI Version	HDMI 2.0a