Philips 6000 Series - Page 4

2
maximum is exceeded, the monitor
damage will not be covered under
warranty�
• Do not knock or drop the
monitor during operation and/or
transportation�
• The USB Type-C port could only be
connected to specify equipment with
fire enclosure in compliance with IEC
62368-1 or IEC 60950-1�
• Excessive usage of the monitor
can cause eye discomfort� It’s
recommended to take shorter breaks
more often at your workstation than
longer breaks and less often� For
example, a 5-10 minute break after
50-60-minute continuous screen use
is likely to be better than a 15-minute
break every two hours� Prevent eye
strain while using the screen for a
constant period by :
• Looking at something varying
distances after a long period of
focusing on the screen�
• Conscious Blinking while you
work�
• Gently closing and rolling your
eyes to relax�
• Reposition your screen to the ap-
propriate height and angle�
• Adjust the brightness and con-
trast to an appropriate level�
• Adjust the environment light-
ing similar to that of your screen
brightness.Avoiduorescent
lighting and surfaces that don’t
reecttoomuchlight.
• Seeing a doctor if your symptoms
worsen�
Maintenance
• To protect your monitor from possible
damage, do not put excessive pressure
on the LCD panel� When moving your
monitor, grasp the frame to lift; do not
lift the monitor by placing your hand
or fingers on the LCD panel�
• Oil-based cleaning solutions may
damage the plastic parts and void the
warranty�
• Unplug the monitor if you are not
going to use it for an extensive period�
• Unplug the monitor if you need to
clean it with a slightly damp cloth� The
screen may be wiped with a dry cloth
when the power is off� However, never
use organic solvents, such as alcohol
or ammonia-based liquids�
• To avoid the risk of shock or
permanent damage to the set, do
not expose the monitor to dust, rain,
water, or excessive moisture�
• If your monitor gets wet, wipe it with
a dry cloth as soon as possible�
• If a foreign substance or water gets in
your monitor, please turn the power
off immediately and disconnect the
power cord� Then, if damaged, send it
to the maintenance center�
• Do not store or use the monitor in
locations exposed to heat, direct
sunlight, or extreme cold�
• To maintain the best performance of
your monitor and use it for a longer
lifetime, please use the monitor in a
location that falls within the following
temperature and humidity ranges:
• Temperature: 0°C-40°C 32°F-104°F
• Humidity: 20%-80% RH
Important information for Burn-in/Ghost
image