Philips 6000 Series - Page 50

48
Q10: Are Philips LCD displays Plug-and-
Play?
Ans.: Yes, the displays are Plug-and-
Play compatible with Windows
11/10/8.1/8
Q11: What is Image Sticking, Image
Burn-in, After Image, or Ghost
Image in LCD panels?
Ans.: Uninterrupted display of still or
static images over an extended
period may cause "burn in", also
known as "after-imaging" or
"ghost imaging", on your screen.
"Burn-in", "after-imaging", or
"ghost imaging" is a well-known
phenomenon in LCD panel
technology. In most cases, the
"Burn-in" or "after-imaging" or
"ghost imaging" will disappear
gradually over a period of
time after the power has been
switched o.
Always activate a moving screen
saver program when you leave
your display unattended.
Always activate a periodic screen
refresh application if your LCD
display will display unchanging
static content.
Warning
Failure to activate a screen saver, or a
periodic screen refresh application may
result in severe “burn-in” “after-image”
or “ghost image” symptoms that will not
disappear and cannot be repaired. The
damage mentioned above is not covered
under your warranty.
Q12: Why is my Display not showing
sharp text, and is displaying
jagged characters?
Ans.: Your LCD monitor works best at
its native resolution of 5120 x
2160. For the best display, please
use this resolution.
Q13: How to unlock/lock my hotkey?
Ans.: To lock the OSD, press and hold
the button while the
monitor is o and then press
button to turn the monitor on.
To un-lock the OSD, press and
hold the button while the
monitor is o and then press
button to turn the monitor on.
  
  
Q14: Where can I nd the Important
information manual mentioned
in EDFU?
Ans.: Important information manual
can be downloaded on the
Philips website support page.
Q15: Why cannot detect my monitor’s
Windows Hello webcam, and also
Face Recognition option is greyed
out?
Ans: To x this issue, you need to
proceed following steps to detect
the webcam device again:
1. Press Crtl + Shift + ESC to launch
the Microsoft Windows Task
Manager.
2. Select ‘Services’ tag.