(43PFL5703, 43PFL5603)
1
2
×4
Note(s)
Ɣ
A wide open space is recommended for assembly.
Ɣ
A Phillips-head screwdriver is required to fasten the stands to the TV set.
Ɣ
When attaching the stand, ensure that all screws are tightly fastened. If the
stand is not properly attached, it could cause the unit to fall, resulting in
injuries as well as damage to the unit.
Ɣ
To remove the stand from this unit, unscrew the phillips-head screws by
reversing the procedure. Be careful not to drop the stand when you remove
it.
Lifting the TV set
Carefully lift the TV set as shown in the illustration and place it onto a
stable, level surface.
Removing cardboard
Remove the cardboard attached to the screen.
Installing the remote control batteries
1
Slide the battery cover off the back of the remote control.
2
Insert the two included batteries (AAA, 1.5V). Be sure the + and –
ends of the batteries line up with the markings inside the case.
3
Slide the cover back into position.
Note(s)
Ɣ
Remove the batteries if not using the remote control for an extended period
of time.
12 .English
Continued on next page.
To Next Page
Loading...
