Philips 8000 Series - Page 21

1 Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off
the beard styler attachment . Do not pull at the
sides of the comb.
2 Rinse the cut hairs off the cutting unit with
lukewarm water.
3 Rinse the cut hairs off the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit from
the beard styler attachment you can remove
any hairs that have accumulated inside the
beard styler. You can also rinse the back of the
cutting unit.
5 Rinse cut hairs out of the beard styler
attachment.
6 Carefully shake off excess water and leave the
comb, cutting unit and beard styler attachment
to dry before next usage.
1
2
7 When the cutting unit is dry attach it to the
beard styler attachment.
21
English