English
3 Place the shaver in the holder (1), tilt the shaver
backwards (2) and press down the top cap to
connect the shaver ('click') (3).
The battery symbol starts to ash, which
indicates that the shaver is charging.
4 Press the on/o button on the SmartClean
system to start the cleaning program.
During the rinsing phase, the rinsing symbol
ashes. When the rinsing phase is done (after
approx. 10 minutes), the rinsing symbol goes out.
After the rinsing phase, the drying phase starts
automatically. During this phase, the drying symbol
ashes. When the drying phase is done (after
approx. 4 hours), the drying symbol goes out.
When the cleaning program is done, the ready
symbol lights up continuously.
30 minutes after the cleaning program and
charging are done, the SmartClean system
switches o automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged. Charging
takes approx. 1 hour.
Note: If you press the on/o button of the
SmartClean system during the cleaning program,
the program stops. In this case, the cleaning or
drying symbol goes out.
Note: If you disconnect the SmartClean system
from its power supply, the cleaning program stops.
41
s8960_27_en_a6_cs6_1116.indd 41 2018/11/16 17:30
To Next Page
Loading...
