Philips 9000 series - Software

English
Shaver
Problem Possible cause Solution
The appliance
does not work
when I press the
on/o button.
The appliance is still
attached to the wall
socket. For safety
reasons, the
appliance can only
be used without
charging cord.
Unplug the appliance and
press the on/o button to
switch on the appliance.
The rechargeable
battery is empty.
Recharge the battery.
The travel lock is
activated.
Press the on/o button
for 3 seconds to
deactivate the travel lock.
The shaving unit is
soiled or damaged
to such an extent
that the motor
cannot run.
Clean the shaving heads
thoroughly or replace
them.
The appliance
does not shave as
well as it used to.
The shaving heads
are damaged or
worn.
Replace the shaving
heads.
Hairs or dirt
obstruct the shaving
heads.
Clean the shaving heads
in the regular way or clean
them thoroughly.
I replaced the
shaving heads,
but the
replacement
reminder is still
showing.
You have not reset
the replacement
reminder.
To reset the replacement
reminder, press and hold
the on/o button for more
than 7 seconds.
51
s8960_27_en_a6_cs6_1116.indd 51 2018/11/16 17:30