Philips 98BDL4650D - Wire-Connecting to Network; Network Settings

98BDL4650D
29
4.7. Wire-connecting to Network
PC
[RJ-45]
[RJ-45]
ROUTER
INTERNET
Network Settings:
1. Switch the router on and enable its DHCP setting.
2. Connect the router to this display with an Ethernet cable.
3. Press [ ] HOME button on the remote control, then select
Setup
.
4. Select
Connect to network
, then press [ ] button.
5. Wait until this display nds the network connection.
6. If the “End User License Agreement” window prompts, accept the agreement.
NOTE: Connecting with a shielded CAT-5 Ethernet cable to comply with the EMC directive.