Philips AC0820 - Filter reset; Storage; Troubleshooting

12 EN
Filter reset
You can replace the lter even before lter replacement alert ( ) displays on
the screen� After replacing a lter, you need to reset the lter lifetime counter
manually�
1 Press the power button to turn on the appliance�
2 Within 10 seconds after power on, press and hold the mode switch button
for 5 seconds to reset the lter lifetime counter�
6 Storage
1 Turn o the air purier and unplug from the power socket�
2 Clean the air purier, air quality sensor and the surface of the lter (see
chapter ‘Cleaning’)�
3 Let all parts air dry thoroughly before storing�
4 Wrap the lter in air tight plastic bags�
5 Store the air purier, lter in a cool, dry location�
6 Always thoroughly wash hands after handling a lter�
7 Troubleshooting
This chapter summarizes the most common problems you could encounter
with the appliance� If you are unable to solve the problem with the information
below, contact the Consumer Care Center in your country�
Problem Possible solution
The appliance
does not work
even though it is
plugged in�
• The lter replacement alert is on but you have not
replaced the corresponding lter� As a result, the
appliance is now locked� In this case, replace the lter
and reset the lter lifetime counter�
The airow that
comes out of
the air outlet
is signicantly
weaker than
before�
• The surface of the lter is dirty� Clean the surface of the
lter (see the chapter "Cleaning")�