Philips AC1214 - Filter Reset; Storage

Filter reset
You can replace filters even if there is
no filter replacement code displayed on
the screen. After replacing a filter, you
need to reset the filter lifetime counter
manually.
1 Touch and simultaneously
for 3 seconds to enter the filter reset
mode (fig.{).
» Code (A3) of the NanoProtect
True HEPA filter displays on the
screen.
2 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect True HEPA filter
(fig.z).
3 Code (C7) of the Nanoprotect Active
Carbon filter displays on the screen
after the lifetime counter of the
NanoProtect True HEPA filter has
been reset (fig.|).
4 Touch and hold for 3 seconds to
force reset the filter lifetime counter
of the NanoProtect Active Carbon
filter and exit the filter reset mode
(fig.}).
16 EN
7 Storage
1 Turn off the air purifier and unplug
from the wall outlet.
2 Clean the air purifier, air quality
sensor and pre-filter (see chapter
‘Cleaning’).
3 Let all parts dry thoroughly before
storing.
4 Wrap the filter and pre-filter
separately in air tight plastic bags.
5 Store the air purifier, the filter and
pre-filter in a cool, dry location.
6 Always thoroughly wash hands
after handling filters.