3 Press the two clips down (1) and
pull the pre-filter towards you (2).
4 If the pre-filter is very dirty, use a
soft brush to brush away the dust
. Then wash the pre-filter under
running tap water.
5 Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
4 Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab.
5 Dry all parts thoroughly with a dry
cotton swab.
6 Reattach the air quality sensor
cover.
Note
• Always keep air quality cover closed
while the air purifier is working.
Cleaning the pre-lter
Clean the pre-filter when F0 is displayed
on the screen.
1 Switch off the air purifier and
unplug from the wall outlet.
2 Pull the bottom part of the front
panel to remove it from the air
purifier.
33EN
To Next Page
Loading...
