34 EN
3 Get started
Installing the
NanoProtect filter
Before using the appliance, remove all
packaging materials of the filter and
place it into the appliance described as
follows:
Note
• Make sure that the side with the tag
is pointing towards you.
1 Pull the top part of the back panel
towards you to release it from the
appliance.
2 Press the clip down and pull the
pre-filter towards you.
3 Remove all packaging materials of
the NanoProtect filter.
4 Place the NanoProtect filter back
into the appliance.
5 Put the pre-filter back into the
appliance, mount the pre-filter onto
the bottom of the appliance first,
and then push the clip on the top of
pre-filter against the appliance.
To Next Page
Loading...
