Philips AC3033/10 - Turning on and off

8 EN
PM2.5
AeraSense sensing technology
accurately detects and quickly
responds to even the slightest particle
change in the air� It provides you with
reassurance with real-time PM2�5
feedback�
Most of the indoor air pollutants
fall under PM2�5 – which refers to airborne particle pollutants smaller than
2�5 micrometers� Common indoor sources of ne particles are tobacco smoke,
cooking, burning candles� Some airborne bacteria and the smallest mold
spores, pet allergen and dust mite allergen particles also fall under PM2�5�
GAS
With an advanced gas sensor, a display
ranging from L1 to L4 shows the level change
of potential harmful gases (incl� VOC, odor,
etc�) detected� L1 indicates best air quality�
Turning on and o
Note:
• For optimum purication performance, close doors and windows�
• Keep curtains away from the air inlet or air outlet�
1 Put the plug of the air purier in the power socket�
2 Touch
to switch on the air purier�
» The air purier beeps�
» The “ ” displays on the screen during warming up� Then the air
purier shows the IAI/PM2�5/Gas level after measuring the air quality�
» The air purier operates in the auto mode with IAI displayed on the
screen (g h)�
3 Touch and hold the
button for 3 seconds to switch o the air purier�
Note: If the air purier stays connected to the electrical outlet after turning
OFF, the air purier will operate under the previous settings when turned ON
again�
PM2.5 level Air quality light color
≤12 Blue
13-35 Blue-purple
36-55 Purple-red
>55 Red
Gas level Air quality light color
L1 Blue
L2 Blue-purple
L3 Purple-red
L4 Red