Philips AC3036/10 - Checking the Filter Status; Switching the Display Indicator; Using the Light On;Off Function; Changing the Mode Setting

9EN
English
Changing the mode setting
You can choose Auto mode, Turbo mode or the Sleep mode by touching the
button�
Auto mode ( ): In Auto mode, the dual-sensor sense the air quality in real-
time and the appliance automatically adjusts the fan speed in accordance
with the ambient air quality, the control panel can automatically adjust display
screen brightness according to the ambient light (g i)�
Turbo mode ( ): In Turbo mode, the air purier operates on the highest
speed (g j)�
Sleep mode ( ): In Sleep mode, the air purier operates quietly at a low
speed� After 3 seconds, the screen dims (g k)�
Switching the display indicator
Note: The appliance displays IAI level by default�
• Touch the button to switch display indicator among PM2�5 /Gas /IAI
(g l & g m & g n)�
Using the light on/o function
With the light sensor, the control panel can automatically turn on, turn o or
dim according to the ambient light� The control panel will be o or dim when the
ambient light is dark� You can touch any button to wake up all lights� Then, if no
further operation, all lights will be o or dim again to match with the ambient
light (g o )�
You can touch the light on/o button manually to turn o all lights and the
control pa nel� Touch any button to wake up all lights (g p)�
Checking the lter status
• Touch the lter status check/reset button to check the lter service life
status (g q)�
» The percentage of remaining service life of the lter displays on the
screen�
Icon color Filter life indication Display (%)
Blue Optimal service life 16-100
Blue-purple Good service life 9-15
Purple-red Service life almost reaches the end 4-8
Red Service life ends, replace the lter 0-3
Note: The appliance goes back to normal display if no operations after
3 seconds�