Philips AC3036/10 - Cleaning the Particle Sensor; Cleaning the Surface of the Filter (Fig S)

11EN
English
Cleaning the particle sensor
Clean the particle sensor every 2 months for optimal functioning of the
appliance�
Note:
• If the air purier is used in a dusty environment, it may need to be cleaned
more often�
• If the humidity level in the room is very high, condensation may develop
on the particle sensor and the air quality light may indicate a more poor air
quality even though the air quality is actually good� If this occurs, clean the
particle sensor�
• The gas sensor doesn’t need to be cleaned�
1 Switch o the air purier and unplug from the power socket�
2 Pull the back cover and remove it from the appliance (g c)�
3 Clean the particle sensor with a damp cotton swab (g r)�
4 Dry all parts thoroughly with a dry cotton swab�
5 Reattach the back cover (g g)�
Cleaning the surface of the lter (g s)
Filter alert light status Action
The lter cleaning alert displays on
the screen�
Clean the surface of the lter with a
vacuum�
1 Switch o the air purier and unplug from the power socket�
2 Pull the back cover and remove it from the appliance (g c)�
3 Pull the lter from the appliance (g u)�
4 Clean the surface of the lter with a vacuum (g t)�
5 Put the lter back into the appliance (g f)�
6 Reattach the back cover� (g g)
7 Put the plug of the air purier in the power socket�
8 Touch the button to switch on the appliance�
9 Touch and hold the lter status check/reset button for 3 seconds to
reset the lter cleaning time�
10 Wash your hands thoroughly after cleaning the lter�