Philips AC3059 - Filter Lifetime Counter Reset; Storage and Troubleshooting; Proper Storage Instructions; Troubleshooting Common Issues

13EN
English
Filter reset
You can replace the lter even before lter replacement alert ( ) displays on the screen.
After replacing a lter, you need to reset the lter lifetime counter manually.
1 Touch the power button for 3 seconds to turn o the appliance and unplug from
power socket.
2 Put the power plug in the power socket (g y).
3 Within 15 seconds after power on, touch and hold and button for 3 seconds to
reset the lter lifetime counter (g z).
6 Storage
1 Turn o the air purier and unplug from the power socket.
2 Clean the air purier, particle sensor and the surface of the lter (see chapter “Cleaning
and maintenance”).
3 Let all parts air dry thoroughly before storing.
4 Wrap the lter in air tight plastic bags.
5 Store the air purier, lter in a cool, dry location.
6 Always thoroughly wash hands after handling the lter.
7 Troubleshooting
This chapter summarizes the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, contact the
Consumer Care Center in your country.
Problem Possible solution
The appliance does
not work properly.
• The lter replacement alert has been on continuously but you
have not replaced the corresponding lter. As a result, the
appliance is now locked. In this case, replace the lter and long
press to reset the lter lifetime counter.
The airow that
comes out of the air
outlet is signicantly
weaker than before.
• The surface of the lter is dirty. Clean the surface of the lter (see
the chapter “Cleaning and maintenance”).