Philips AC6710 - Getting Started; Installing Filters

English
25EN
3 Getting started
Installing filters
Remove all packaging of the filters
before using the appliance. Unpack
them and place them into the
appliance described as follows:
Note
• There is one set of filters on
each side of the appliance.
Each side is equipped with
one pre-filter and two air
purification filters.
• Make sure that you place the
air purification filters in the
appliance first and then the
pre-filter.
• Make sure that the side with the
tag is pointing towards you.
1 Remove all packaging materials
of the air purification filters.
2 Pull the top part of the side
panel to remove it from the
appliance.
3 Press the two clips down and
pull the pre-filter towards you.
4 Put the unpacked air purification
filters into the appliance.
Note
• Put the NanoProtect HEPA
filter Series 3 (FY6172) in the
appliance first, and then the
NanoProtect Active Carbon
filter (FY6171).