How to fix Philips Water Dispenser safety lock if it does not work?
If the safety lock on your Philips Water Dispenser does not work, it is possible that the safety lock function is turned off. Long press the safety lock button for 10 seconds to turn it on.
Why is my Philips ADD5980M/58 Water Dispenser not dispensing hot water?
If your Philips Water Dispenser isn't dispensing hot water, first, make sure it’s properly plugged in and turned on. Next, check if there's water in the tank and fill it if needed. Also, verify that the dispense button isn't locked by pressing the safety lock button. Finally, the appliance may require descaling, so descale it according to the instructions in chapter 5.
Why is my Philips Water Dispenser not dispensing cold water?
If your Philips Water Dispenser isn't dispensing cold water, ensure it is connected to a power source and turned on. Also, check if there is water in the tank and fill it if necessary. If it's the first time you're using it, follow the first-time cleaning instructions in chapter 5. Finally, check if the cooling system is turned off. To turn it on, long press and for 3 seconds. You should hear a cooling sound, and the Cooling Indicator will light up. If the issue still persists, please contact consumer care.
Why is the water flow slow in my Philips ADD5980M/58 Water Dispenser?
If the water flow from your Philips Water Dispenser is slow, it could be due to limescale buildup in the heating element. Descale the appliance following the descaling instructions. Another possible cause is air in the water pump. Fill up the water tank to resolve this.
Why is the water flow unstable in my Philips Water Dispenser?
If the water flow from your Philips Water Dispenser is unstable, it is probably caused by limescale buildup in the heating element. You should descale the appliance following the descaling instructions.
Why does the water from my Philips Water Dispenser taste odd?
If the water from your Philips Water Dispenser tastes odd, it might be because the appliance wasn't thoroughly cleaned after descaling; in this case, follow steps 6-9 in chapter 5 of the descaling instructions to clean the appliance. Another reason could be that the filtered water has been sitting for too long. Discard the remaining water and refill with fresh tap water. Lastly, the filter may need replacing with a new filter cartridge.
Why Philips ADD5980M/58 Water Dispenser display panel does not light up?
If the display panel of your Philips Water Dispenser doesn't light up, it might be in sleep mode. Simply touch any button to wake it up. Alternatively, ensure the appliance is properly connected to a power source and turned on. If the issue persists after these steps, contact consumer care.
What to do if Philips ADD5980M/58 Water Dispenser water shortage indicator flashes?
If the water shortage indicator flashes on your Philips Water Dispenser, it means that either there is no water in the water tank, so you should fill it up, or the filter is blocked, so you should replace it with a new filter cartridge.
What to do if Philips ADD5980M/58 Water Dispenser water tank is leaking?
If the water tank of your Philips Water Dispenser is leaking, it might be overfilled. Ensure you only fill the water tank up to the maximum water level. If leakage continues after reducing the water level, contact consumer care.
What does it mean when Safety Lock and 90? flash on Philips ADD5980M/58 Water Dispenser?
If the Safety Lock and 90? indicators are flashing on your Philips Water Dispenser, accompanied by a buzzing sound, it indicates that the heating element is abnormal. Cut off the power and wait for 5 minutes. Plug it in again and descale according to the instructions in chapter 5. If the problem persists, contact consumer care.
Overview of the control panel functions including On/Off, Safety Lock, Dispense, Descale, Cooling, Water Shortage, Filter Lifetime, Temperature, and Volume selections.
Instructions for initial setup and cleaning before first use, including removing packaging, washing components, and initial cleaning steps.
Detailed instructions on operating the dispenser, from plugging in to dispensing water, including drip tray adjustment and selecting temperature/volume.
Procedure for preparing the filter cartridge and appliance before initial use, including soaking filter and cleaning tanks.
Instructions for regular cleaning of internal components like the water tank and lid, emphasizing safe methods and frequency.
Step-by-step guide for descaling the appliance using a citric acid solution to maintain performance and efficiency.
Guide to diagnosing and resolving common issues with the dispenser, covering display, dispensing, leakage, and water flow problems.
Information on obtaining support, warranty details, and contact information for consumer care centers or local dealers.
List of all items included in the product packaging, such as the water dispenser unit, filter cartridge, user manual, and power cord.
General| Brand | Philips |
|---|---|
| Model | ADD5980M/58 |
| Category | Water Dispenser |
| Language | English |
To Next Page
