Philips AJ3650 - Storing Preset Stations; Listening to Radio

TUNING TO RADIO STATONS
Automatic tuning
•Press and hold TUNING +/- to automatically tune to the next or previous station of
sufficient reception.
Manual tuning
•Press TUNING +/- briefly or repeatedly until you reach the desired frequency.
To improve reception:
Extend and position the pigtail fully to obtain optimum reception.
STORING PRESET STATIONS
You can store up to a total of 15 radio stations in the memory.
Manual scanning
1. Tune to your desired station (see TUNING TO RADIO STATONS ).
2. To store a preset station, hold down
PRESET +/- briefly until the preset number
appears.
3. Press PRESET +/- repeatedly to select the preset station number.
•You can overwrite a preset station by storing another frequency in its place.
Automatic scanning
1. Press and hold AUTO SCAN until the frequency digits start flashing.
™
The set scans all available stations and stores them as preset stations in
sequence.
™ The set starts to play preset 1 when finishes scanning.
LISTENING TO RADIO
1. Press RADIO once to switch on the radio.
™ Display shows the radio frequency of the last selected station briefly
before returning to the clock time. Your preset station is also shown if you
are listening to a preset station.
2. Adjust volume by turning VOLUME .
3.
Press RADIO to switch off.
Helpful hints:
AJ3650_12_EN 1/25/08 14:49 Page 9