Philips AJB3552/12 - Listen to a Preset DAB+ Radio Station; Show DAB+ Information; Remove Invalid DAB+ Station; Select DRC Setting

9
Select DRC setting
While listening to DAB+ radio, you can change
DRC (Dynamic Range Control) settings to add/
remove a degree of compensation for audio
performance.
1 In DAB+ mode, press and hold MENU
for over 3 seconds.
2 Press / until [DRC] is displayed.
3 Press SELECT to conrm.
4 Press / repeatedly to select an
option:
• [DRC off]: DRC is switched off.
• [DRC high]: DRC is switched on.
Recommend using this setting in
noisy environment.
• [DRC low]: DRC is set to half
normal level.
5 Press SELECT to conrm the selection.
4 Press SELECT to conrm.
Searching starts. »
5 When searching is complete, press
SELECT again to start playing.
Listen to a preset DAB+
radio station
1
Press / to select a preset DAB+
radio channel.
2 Press SELECT to conrm.
Show DAB+ information
While listening to DAB+ radio, press INFO
repeatedly to scroll through the following
information (if available):
Dynamic Label Segment (DLS) »
Signal strength »
Program type (PTY) »
Ensemble Name »
Channel and frequency »
Signal error rate »
Bit rate and audio status »
Date »
Remove invalid DAB+ station
You can remove all invalid stations from the
available DAB+ station list.
1 In DAB+ mode, press and hold MENU
for 3 seconds.
2 Press / repeatedly until [Prune] is
displayed.
3 Press SELECT to conrm.
» [No][Yes] is displayed.
4 Press / to select [Yes].
5 Press SELECT.
All invalid stations are removed. »
EN