Philips AquaTouch 5000 Series - Part Replacement; Replacing Shaving Heads

1
2
4 Turn the retaining rings counterclockwise and
remove them. Place them aside in a safe place.
5 Remove the shaving heads from the shaving
head holder.
Discard the used shaving heads immediately to
avoid mixing them with the new shaving heads.
6 Place the new shaving heads in the shaving
head holder.
Note: Make sure that the projections of the
shaving heads fit exactly into the recesses of
the shaving head holder.
1
2
7 Place the retaining rings back onto the shaving
heads and turn them clockwise to reattach the
retaining ring.
Each retaining ring has two recesses and two
projections that fit exactly in the projections
and recesses of the shaving head holder.
35
English