Philips AZ127 - Play from an External Device; Play Tape

8 EN
Play from an external device
You can also listen to an external audio device
through this unit.
1 Switch the source selector to AUDIO-IN/
CD.
2 Connect an audio cable (3.5mm, not
supplied)to:
• the AUDIO-IN socket on the unit.
• the headphone socket on an external
device.
3 Play the external device (see the device's
usermanual).
Note
• The AUDIO-IN socket is not for headphones.
• The display panel lights off when the unit plays from the
external device.
Audio-in
Play tape
Note
• The unit will turns off automatically after an elapsed
time of inactivity at tape mode.
1 Slide the source selector to TAPE.
» The unit turns on automatically.
2 Press on main unit to open the tape
door.
3 Load the tape with the open side upward
and the full spool to the right.
4 Press on main unit to start play.
• To pause/resume play, press on main
unit .
• To rewind or fast-forward, press /
on main unit .
• To stop play, press .
» The unit turns off automatically.
Note
• In playback mode, cassette will be stopped
automatically when playback reaches the end.