16
• During USB play, press USB to
select one of the following play
modes.
• ALL RPT: repeat all the tracks
in one folder.
• OFF RPT: repeat mode is
turned o.
Note
•
Support a USB storage device up to 32GB.
• This product may not be compatible with
certain types of USB storage device.
• If you use a USB extension cable, USB
HUB, or USB multi-reader, the USB storage
device may not be recognized.
• Digital camera PTP and MTP protocols are
not supported.
• Do not remove the USB storage device
while it is being read.
• DRM-protected music les (MP3) are not
supported.
• Support a USB port: 5V , 500mA.
Set display brightness
You can press DIM repeatedly to select
a dierent brightness level of the
display panel on this product.
If you select AUTO OFF, LED message is
switched o after 10 seconds of button
inactivity.
Apply factory settings
In case of no response from this
product , you can reset this product to
the default settings programmed at the
factory.
1 In HDMI ARC mode (press HDMI
ARC), on the remote control, within
six seconds, press
twice then
Volume - once, and then hold
down BASS -.
MP3 player
Connect your MP3 player to play your
audio les or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1 Using the 3.5mm stereo audio
cable, connect the MP3 player to
the AUDIO IN connector on this
product.
2 Press repeatedly AUDIO IN on the
remote control until AUDIO IN is
displayed on the display panel.
3 Press the buttons on the
MP3 player to select and play audio
les or music.
USB storage devices
Enjoy audio on a USB storage device,
such as an MP3 player and USB ash
memory, etc.
What you need
• A USB storage device that is
formatted for FAT16 or FAT32 le
systems, and complies with the
Mass Storage Class.
• An MP3 le on a USB storage
device.
1 Connect a USB storage device to
this product.
2 Press USB on the remote control.
3 Use the remote control to control
play.
• Press
to start, pause or
resume play.
• Press
/ to skip to the
previous or next track.
EN
To Next Page
Loading...
