BDL4830QL
iv
Regulatory Information
CE Declaration of Conformity
We declare under our responsibility that the product is in conformity
with the following standards:
EN60065:2002+A1:2006+A11:2008+A2:2010+A12:2011 (Safety
EN61000-3-2:2006 +A1:2009+A2:2009 (Limits for Harmonic
Current Emission)
EN61000-3-3:2008 (Limitation of Voltage Fluctuation and Flicker)
EN 50581:2012 (Technical documentation for the assessment of
electrical and electronic products with respect to the restriction of
hazardous substances)
following provisions of directives applicable:
2006/95/EC (Low Voltage Directive)
2004/108/EC (EMC Directive)
2009/125/EC (ErP Directive, EC No. 1275/2008, 642/2009
Implementing Directive for Standby and Off mode power
consumption)
93/68/EEC (Amendment of EMC and Low Voltage Directive) and is
produced by a manufacturing organization on ISO9000 level.
2011/65/EU (RoHS 2 Directive)
Federal Communications Commission (FCC)
Notice (U.S. Only)
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
to radio or television reception, which can be
user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
and receiver.
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
the party responsible for compliance could void the
Use only an RF shielded cable that was supplied with the display when
connecting this display to a computer device.
expose this appliance to rain or excessive moisture.
THIS CLASS B DIGITAL APPARATUS MEETS ALL REQUIREMENTS
OF THE CANADIAN INTERFERENCE- CAUSING EQUIPMENT
REGULATIONS.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
To Next Page
Loading...
