Philips BT3500 - Using Bluetooth Connectivity; Connecting a Bluetooth Device; Manual Bluetooth Pairing

6 EN
Switch to standby mode
• In Bluetooth mode, if Bluetooth connection
is invalid or music playback is stopped
for 15 minutes, this speaker switches to
standby mode automatically.
• In Audio-in mode, if the audio-in cable is
disconnected or music playback is stopped
for 15 minutes, this speaker switches to
standby mode automatically.
» To return to Bluetooth or Audio-in mode,
slide the source selector to OFFrst,then
to or AUDIO IN position.
4 Use Bluetooth
devices
With this speaker, you can listen to audio from
Bluetooth-enabled devices and control the
incoming call through Bluetooth.
Connect a device
Note
• Make sure that your Bluetooth device is compatible
with this speaker.
• Before pairing a device with this speaker, read its user
manual for Bluetooth compatibility.
• The speaker can memorize a maximum of 4 paired
devices.
• Make sure that Bluetooth function is enabled on your
device, and your device is set as visible to all other
Bluetooth devices.
• Any obstacle between this speaker and a Bluetooth
device can reduce the operational range.
• Keep away from any other electronic device that may
cause interference.
Connect a device manually
Note
• The operational range between this speaker and a
Bluetooth device is approximately 10 meters (30 feet).
1 Slide the source selector to .
» TheLEDindicatorashesinblue.
2 On your Bluetooth device, enable
Bluetooth and search for Bluetooth devices
(refer to the user manual of the device).
3 When [BT3500] is displayed on your
device, select it to start pairing and
connection. If necessary, enter default
password “0000”.