Philips BTB2370 - Show Rds Information; Select a Preset Radio Station

15EN
1 In tuner mode, press /MENU to access
the FM tuner menu.
» [SCAN] is displayed.
2 Press OK, and then press / to scroll
through the menu options:
• [STRONG] (strong stations): scan
stations with strong signals only.
• [ALL] (all stations): scan all available FM
radio stations.
3 Press OK to select an option, and then
press /MENU to exit the menu.
4 In FM tuner mode, press PROG/SCAN.
» The stations scanned are based on the
selection at step 2.
» Theunitbroadcaststherstscanned
FM radio station.
Store FM radio stations manually
1 Tune to an FM radio station.
2 Press PROG/SCAN to activate storing
mode.
» [PROG] (program) blinks.
3 Press ALBUM/PRESET / repeatedly
to select a radio frequency.
4 Press PROG/SCANagaintoconrm.
» The frequency of the preset station is
displayed.
5 Repeat the above steps to store more FM
stations.
Note
• To remove a pre-stored station, store another station
in its place.
Select a preset radio station
• In FM mode, press ALBUM/PRESET /
to select a stored radio frequency, and
then press OKtoconrm.
Show RDS information
Radio Data System (RDS) is a service
that allows FM stations to show additional
information.
1 Tune to an RDS station.
2 Press INFO repeatedly to scroll through
the following information (if available).
• Radio text message
• Program type
• Frequency
Select stereo/mono broadcast
Note
• Stereo broadcast is the default setting for tuner mode.
• For stations with weak signals: to improve the reception,
switch to monaural sound.
• In FM tuner mode, press OK to switch
between mono and stereo broadcast.