Philips CD163 - Page 8

PLAY
ADJUSTING THE SOUND LEVEL (-VOLUME +)
(for CD165 only)
CAUTION:
— Usethe-VOLUME +keys (on the remote control)
only if the player is connected to an amplifier or
HiFi system without its own remote control.
Note:
— The setting chosen with -VOLUME+ will be
cancelled when the player is switched off.
© Hold -VOLUME down.
~ VOL lights up; the output signal from the player
will now decrease gradually.
~ The successive steps are shown on the display.
e Release the key as soon as the required sound
level is obtained.
¢ Hold VOLUME + down.
- VOL lights up, the output signal will now increase
again gradually to the maximum level.
- The successive steps are shown on the display.
¢ Release the key as soon as the required sound
level is obtained.
STORING A PROGRAMME (PROGRAM and i«< >>)
You can store 30 tracks from each CD in any required sequence in a program.
FULL lights up if you exceed the maximum of 30 tracks.
Pil f
be de
PROGRAMMING / SYSTEM ASPECTS
PLAYING THE PROGRAMME (PLAY)
e Press PLAY.
Play starts with the first number of the programme.
All keys (except program) can be used during pro-
grammed play.
Search for a particular passage is only possible within
the track being played.
ERASING A PROGRAM
(STOP/CP or OPEN*CLOSE)
e¢ Press STOP/CP twice or, if the CD has already
stopped, just once; you can also press
OPEN*CLOSE straight away.
— The programme has now been erased.
INTERFERENCE TO TUNER
NOTE!
— Toavoidunnecessary interference, always switch
off the CD player when you are in Tuner mode.
In STOP mode, press PROGRAM to open the memory.
PROGA lights up and ij starts flashing.
Press le or >» until the desired track number appears under TRACK. -
Press PROGRAM again.
The track number has now been stored in the player's memory.
Select the other track numbers required and store each track by pressing PROGRAM.
The
number
of
tracks
and
the
playing
time
of
your
programme
will
be
shown
under
TRACK
and
TOTAL
TIME.
aie,
ee
Press STOP/CLEAR to stop programming.
PCS 64 114