Note: The set is standard adjusted for a mono microphone. If
you wish to use a stereo microphone, press AUX for
more than 5 seconds. The set will display MONO ?.
Press NO to select STEREO or YES to select MONO.
STEREO MIC or MONO MIC will be displayed.
Important:
If you want to play the recorded CDR disc on any
regular CD player, it must first be finalised. See
finalising discs.
Finalised CDRW discs play only on CDRW compatible
CD players.
Finalizing a CDR(W) disc is a simple procedure, necessary to:
– play a recorded CDR on a standard CD player
– play a recorded CDRW on a CDRW compatible CD player
and CD recorder
– avoid further unwanted recordings on a disc
– avoid erasure of tracks on a CDRW
Notes:
– Finalizing will take about 2–4 minutes.
– After finalization of the CDR(W), CDR
(W) changes to
CD on
the display.
– During finalization no other operating commands can be
executed.
Auto finalizing
When you use either CD™CD or COMPILE CD, your recordings
will be finalized automatically (see.“High speed recording and
automatic finalizing”).
Manual finalizing when recording is in progress
1 Press FINALIZE on the set during recording.
➜ AUTO FINAL ? is displayed.
2 Press YES to confirm.
➜ FINALIZE is shown. The finalization will start after
recording and the actual finalizing time left will start to
count down.
Manual finalizing when recording is stopped
1 Insert the CDR(W) you want to finalize in the CD recorder
tray.
2 Press CDR to select the CD recorder.
3 Press FINALIZE on the set.
➜ FINALIZE ? is displayed.
4 Press YES to start finalizing.
➜ FINALIZE is shown, FINAL is displayed and the actual
finalizing time left starts to count down.
To Next Page
Loading...
Need help?
General
