Do you have a question about the Philips CDR775 and is the answer not in the manual?
Type | CD Recorder |
---|---|
Audio Sampling Rate | 44.1 kHz |
Bit Depth | 16-bit |
Frequency Response | 20 Hz - 20 kHz |
Signal to Noise Ratio | > 90 dB |
Dynamic Range | > 90 dB |
Digital Inputs | Coaxial, Optical |
Digital Outputs | Coaxial, Optical |
Power Consumption | 25 W |
Disc Formats | CD-R, CD-RW |
Analogue Inputs | 2 x RCA |
Analogue Outputs | 2 x RCA |
Headphone Output | 1 x 6.35mm Jack |
Outlines the three main service parts of the CDR775 unit.
Covers general, input/output, and audio performance specifications of the CDR775.
Warns about ESD, laser radiation, and electrical shock hazards during service.
Details front panel controls, rear connections, and display indicators.
Describes different recording modes for internal CD and external sources.
Shows wiring diagrams for the CDR775 and CD loader.
Provides visual breakdowns of the CDR775 unit and CD loader components.
Presents high-level block diagrams of the CDR775 system components.
Shows detailed circuit diagrams for various boards like Display, IR, and ON/OFF.
Details the circuit diagram for the PSU 20PS317.
Explains dealer mode and diagnostic test procedures for player status.
Details tests for software versions and defective components.
Provides a flowchart for diagnosing issues with the CDR module.
Provides a flowchart for diagnosing CD module issues including power, display, and TOC.
Details display board components, functions, and testing procedures.
Describes the PSU 20PS317, its pins, start-up, regulation, and circuit functions.
Provides an overview of the CD main board and its required supply voltages.
Provides an alphabetical list of signal names and their descriptions.
Lists mechanical spare parts for CDR775, CD loader, and other units.
Lists spare parts for the CD loader VAL1250 and I/O board.
Lists spare parts for the Power Supply Unit 20PS317.