Philips CE153DR - 6 Listen to DAB Radio Stations; Switch to DAB Mode; Scan for On-Air Stations

15EN
Receive trafc announcement
If you want to receive trafc announcement,
enable the TA (Trafc Announcement) function.
1 Press and hold to access the system
menu.
2 Press / repeatedly until [TA ON] or
[TA OFF] is displayed.
3 Rotate to select a setting.
• [TA ON]: When a trafc
announcement is on air, the system
automatically switches to the tuner
mode and begins to broadcast the
trafc announcement. When the trafc
announcement is over, the system
returns to the previous mode.
• [TA OFF]: Trafc announcement does
not cut in.
Tip
•
When a trafc announcement cuts in, you can press
to switch the system to the previous mode.
Synchronize the system clock
You can synchronize the system clock with an
RDS station that transmits time signals.
1 Press and hold to access the system
menu.
2 Press / repeatedly until [CT ON]
or [CT OFF] is displayed.
3 Rotate to select a setting.
• [CT ON]: Synchronize the
system clock with the RDS station
automatically.
• [CT OFF]: The automatic clock
synchronization with RDS station is
disabled.
Tip
•
The accuracy of time depends on the RDS station that
transmits time signals.
6 Listen to DAB
radio stations
Note
•
Make sure that the DAB radio receiver is securely
connected.
• For optimal reception, securely connect a DAB radio
antenna to the DAB radio receiver and extend it.
• Check with local retailer or go to www.WorldDAB.org
for applicable DAB radio frequencies in your area.
Switch to DAB mode
1
Press AS/SOURCE repeatedly to switch
the source to [DAB/DAB+].
2 Press / repeatedly to select a band:
DAB1, DAB2, or DAB3.
Scan for on-air stations
Note
•
The operation does not replace the stations that are
programmed in each band.
1 Press and hold to access the system
menu.
» [DAB SCAN] is displayed.
2 Press .
» [SCANNING] is displayed.
» The product starts scanning for on-air
DAB radio stations.
» The detected stations are saved in the
ash memory.