Philips DC146 - Basic Functions; Switching the System On and Off

12
English
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press STANDBY-ON 2 or SOURCE
(POWER on the remote control).
➜ The system will switch to the last selected
source.
● Press DISC, TUN, iPOD or AUX on the
remote control.
➜ The system will switch to the selected source.
To switch the system to standby mode
● Press STANDBY-ON 2 (or POWER on the
remote control).
To switch the system to Eco-power
standby mode
● Press and hold STANDBY-ON (POWER on
the remote control) for more than 2 seconds.
➜ The backlight for clock display is dim.
Power-saving automatic standby
The power-saving feature automatically switches
to standby 15 minutes after a CD playback has
ended and no control is operated.
MICRO SYSTE M DC14 6
SOURC E
DOCK
DBB
STANDBY
-
ON
VOL
VOL
TUNING
REPEAT
CD/CD
-
R/CD
-
RW COMPATIBLE
PRESE T
iR
Adjusting volume and sound
1 Press VOL +/- to adjust volume.
➜ Display shows the volume level: VOL and a
number from 0-32.
2 Press DBB to switch bass enhancement on or
off.
➜ Display shows: if the DBB is activated.
3 Press MUTE on the remote
control to interrupt sound
reproduction instantly.
➜ Playback will continue
without sound.
● To activate sound reproduction
you can:
– press MUTE again;
– adjust the volume controls;
– change source.
MUTE
OK
pg001-pg021_DC146_12_Eng 6/23/08, 12:1412