English
17
select CD or press CD on the remote.
2 Insert a disc into the disc loader..
➜ Make sure the label side is facing up.
➜ Make sure you have removed any other disc
from the slot loader.
3 Press ÉÅ to start playback.
4 At any time, simply press 9 to stop playback.
Basic playback controls
To play a disc
● Press ÉÅ to start playback.
➜ The current track number and elapsed
playing time of the track are displayed during
disc playback.
To select a different track
● Press S/T (or ¡ / ™ on the remote
control) once or repeatedly until the desired
track number appears in the display.
● You can also use the Numerical Keypad
(0~9) on the remote to select a track directly.
● If you have selected a track number shortly after
loading a disc or in the PAUSE position, you will
need to press ÉÅ to start playback.
Te xt display during playback
In CD mode
● Press DISPLAY repeatedly to see the
following information.
➜ Tr ack number and elapsed playback time of
current track.
➜ Tr ack number and total elapsed playback
time.
➜ Tr ack number and remaining playback time
of current track.
➜ Tr ack number and total remaining playback
time.
➜ Clock time.
In MP3-CD mode
● Press DISPLAY to display the ID-3
information if available and the clock time.
Important!
The lens of the CD player should never be
touched.
Loading a disc
This CD player plays Audio Discs including CD
Recordables, CD-Rewritables and MP3 CD.
● CD-ROM, CD-I, CDV, VCD, DVD or computer
CDs, however, are not possible.
● DRM-protected WMA disc is not supported.
1 Press SOURCE on the top of the system to
CD/MP3-CD Operation
TIMER
iPod
pg001-029_DCM230_37-Eng 12/6/07, 16:2217
To Next Page
Loading...
