Philips DCM276 - Power Connection Guide; Automatic Radio Tuning; Clock Setting Procedure

11
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to the power supply.
[AUTO INSTALL - PRESS PLAY KEY] »
is displayed.
2 Press on the main unit to start
installation.
The unit automatically stores radio »
VWDWLRQVZLWKVXIÀFLHQWVLJQDOVWUHQJWK
When all the available radio stations »
DUHVWRUHGWKHÀUVWSUHVHWUDGLRVWDWLRQ
is broadcast automatically.
Set clock
Note
You can set the clock in the standby mode 
only.
1 Press PROG/CLOCK SET to enter the
clock setting mode.
[SET CLOCK] (set clock) scrolls on »
the screen.
2 Press / repeatedly to select 12 hour
or 24 hour format.
3 Press PROG/CLOCK SETWRFRQÀUP
The hour digits are displayed and begin »
to blink.
4 Press / to set the hour.
5 Press PROG/CLOCK SETWRFRQÀUP
The minute digits are displayed and »
begin to blink.
6 Press / to set the minute.
7 Press PROG/CLOCK SETWRFRQÀUPWKH
clock setting.
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Note
If you are not going to use the remote control 
for a long time, remove the batteries.
Do not use old and new or different types of

batteries in combination.
Batteries contain chemical substances, so they

should be disposed of properly.
Connect power
Caution
Risk of product damage! Ensure that the 
power supply voltage corresponds to the
voltage printed on the bottom of the unit.
Before connecting the AC cord, ensure you

have completed all other connections.
Note
The type plate is located on the rear of the 
main unit.
1 Connect the AC cord to the AC outlet.
English
EN
Downloaded From Disc-Player.com Philips Manuals