Philips DCM292/12 - Automatic Radio Station Installation; Setting the Clock; Powering On the Unit

13
7 Press PROG/CLOCK SETWRFRQÀUPWKH
clock setting.
Turn on
1
Press .
The unit switches to the last selected »
source.
Switch to standby
1 Press again to switch the unit to
standby mode.
The clock (if set) appears on the »
display panel.
To switch the unit to Eco Power Standby
mode:
1 Press and hold for more than 2
seconds.
The backlight on the display panel »
turns off.
Tip
The unit switches to Eco Power Standby mode 
after 15 minutes in standby mode.
To switch between standby mode and Eco
Standby Mode:
1 Press and hold for more than 2
seconds.
the  DC IN jack on the main unit.
the wall outlet.
Auto install radio stations
When you connect power and no radio
stations are stored, the unit automatically begins
to store radio stations.
1 Connect the unit to the power supply.
[» AUTO INSTALL PRESS -- PLAY
KEY](auto install press -- play key) is
displayed.
2 Press on the main unit to start
installation.
The unit automatically stores radio »
VWDWLRQVZLWKVXIÀFLHQWVLJQDOVWUHQJWK
When all the available radio stations »
DUHVWRUHGWKHÀUVWSUHVHWUDGLRVWDWLRQ
is broadcast automatically.
Set clock
Note
You can set the clock in the standby mode 
only.
1 Press and hold PROG/CLOCK SET to
enter the clock setting mode.
[» SET CLOCK](set clock) scrolls on the
screen.
2 Press / repeatedly to select 12 hour
or 24 hour format.
3 Press PROG/CLOCK SETWRFRQÀUP
The hour digits are displayed and begin »
to blink.
4 Press / to set the hour.
5 Press PROG/CLOCK SETWRFRQÀUP
The minute digits are displayed and »
begin to blink.
6 Press / to set the minute.
English
EN