Philips DCM5090/10 - Additional Features and Information; Sleep and Alarm Timers; Connecting External Audio Devices

17
English
 Press 
» The alarm timer is set and activated.
Activate and deactivate the alarm
timer
In standby mode, press 
repeatedly to activate or deactivate the alarm
timer.
» If the alarm timer is activated,
is displayed
» If the alarm timer is deactivated,
disappears.
Note
 If CD/USB/iPod/iPhone/iPad source is selected,
but no disc is placed or no USB/iPod/iPhone/
iPad is connected, the FM TUNER is selected
automatically.

You can also listen to an external audio device
through this docking system.
1 Press  to select MP3 link
source.
2 Connect the supplied MP3 link cable to:
 the  jack on the back of
the unit
 the headphone jack on the device
3 Start to play the device. (See the device

8 Other features
Set the sleep timer
This docking system can switch to standby
automatically after a set period of time.
1 When the unit is turned on, press 
TIMER repeatedly to select a set period

» When sleep timer is activated,
is
displayed.
To deactivate sleep timer
1 Press  repeatedly until
[
» When sleep timer is deactivated,
disappears.
Set the alarm timer
This docking system can be used as an alarm
clock. You can select CD, FM TUNER, iPod/
iPhone/iPad, or USB as alarm source.
Note
 Ensure that you have set the clock correctly.
1 In standby mode, press and hold 
TIMER until [SET TIMER
scrolls on the display.
2 Press CD, USB, DOCK, or TUNER to
select a source.
3 Press 
» The hour digits are displayed and begin
to blink.
4 Press / to set the hour, and then
press  again.
» The minute digits are displayed and
begin to blink.
5 Press / to set the minute.
EN