Need help?Do you have a question about the Philips DFR9000/01 and is the answer not in the manual?
General| Power output | 2 x 100W (RMS at 8 ohms) |
|---|---|
| Total harmonic distortion | <0.1% (1kHz, 50W) |
| Input sensitivity | 200 mV |
| Tuning range | FM: 87.5 - 108 MHz |
| Frequency response | 20 Hz - 20 kHz |
| Video Connections | Composite video input/output |
| Input Impedance | 47 kOhms (line) |
Information on 13 Amp plug, fuse replacement, and correct wire connection for safety.
Critical warnings for safe operation, connection, and handling of the receiver to prevent hazards.
Detailed explanation of each button, display, and indicator on the receiver's front face.
Instructions for connecting loudspeakers and radio antennas to the receiver.
Details on connecting various audio/video devices via input ports.
Explanation of core buttons like Power, Select, Source, and navigation controls.
Step-by-step guide for connecting the receiver to a TV using SCART/RGBS cables.
Connecting digital sources like satellite receivers and DVD players via optical/coaxial.
Instructions for connecting HDMI-enabled devices like HDTVs and SACD players.
Basic guidelines and steps for connecting speakers to the receiver terminals.
Setting speaker size and distance parameters for optimal surround sound.
How to select and switch between different audio/video sources connected to the receiver.
Controlling volume, bass, treble, loudness, and surround speaker levels.
How to select surround modes based on connected speakers and input signal.
Details on timer, audio delay, centre width/gain, night mode, audio in, and digital out settings.
Solutions for power, display, standby, and remote control response problems.
Resolving issues like poor sound, no sound, reversed channels, and volume level problems.
Resolving issues with no picture, incorrect resolution, or wrong input connections.
Troubleshooting bad radio reception, interference, and DAB signal issues.
Resolving problems like no sound, no digital surround, or incorrect speaker setup.
Solutions for issues with recording from devices or digital outputs, and DVD track recording.
Power amplifier output, dynamic power, signal-noise ratio, and frequency response.
Specifications for digital/analogue video inputs/outputs and resolutions.
To Next Page
