11User Manual
Preheat:
Preheat On Screen Preheat Off Screen
When using a humidier, the device can preheat the water tank for up to 30 minutes prior to starting therapy.
In order to activate the preheat mode, the blower must be “off” and a humidier must be attached. When “Preheat”
is selected, you will be able to turn the control dial to choose between “on” or “off”. Press the control dial again to
make your selection. During the 30 minute preheat, you will still be able to use the control dial to select other menu
options from the Home screen.
Note: This screen only displays when a humidier is attached.
My Provider:
When you select “My Provider,” you will be able to view the following screens. You cannot change settings in the
Provider menu. These screens are only for reference. Your home care provider may periodically ask you for this
information.
Icon Text Description
Device Info This screen displays your therapy device information: serial number, model and
software version.
Provider Contact
Info
This screen will display the contact information for your provider if it has been
uploaded to your device.
Phone-In This screen displays the total therapy hours for the device, the total blower
hours, the total number of days used when the sessions were greater than 4
hours, and a compliance check number used by your home care provider to
validate that the data provided by you is the data taken from this screen.
A-TRIAL A-Trial If Auto-Trial mode is available, this screen displays Days: xx/xx (where xx/xx is
the number of accumulated trial days / number of selected trial days). Available
on the Auto CPAP device.
90%
Pressure
90% Pressure This screen displays the nightly value of 90% Pressure for the most recent 1
day time frame. It also displays the average of these individual nightly values of
90% Pressure over a 7 day and a 30 day time frame. Available on the Auto CPAP
device.
To Next Page
Loading...
