English
42
Record to Hard Disk (continued)
TIPS: Setting an appropriate recording mode is important as it determines the picture quality and
recording time to the HDD or a recordable DVD, see page 38.
About timer recording
Use the timer recording to automatically
start and stop a recording at a later date/
time. This recorder will tune to the right
programme channel and begin recording
at the speci ed time.
With this recorder, you can schedule up
to 25 recordings at a time and up to 6
(six) hours for each recording. During
timer recording, changing the recorder’s
channel is not possible.
Note: If the scheduled timer recording is
longer than 6 (six) hours, it will split into two
or more titles.
There are three ways to
programme a timer recording
– Using the GUIDE Plus+ system
– Using the ShowView / VIDEO Plus+
system
– Using manual timer recording
About ‘VPS/PDC’
‘VPS’ (Video Programming System) or
‘PDC’ (Programme Delivery Control) is
used to control the start and duration of
TV channel recordings. If a TV
programme starts earlier or ends later
than was scheduled, this recorder will
then turn on and off at the correct time.
Timer recording (GUIDE
Plus+ system)
To schedule a recording with the GUIDE
Plus+ system, simply select the desired
programme from the channel list.
A Turn on the TV to the correct
programme number for the recorder
(e.g. ‘EXT’, ‘0’, ‘AV’).
B Turn on the recorder and press GUIDE
on the remote control.
The GUIDE Plus+ screen appears.
Note: If the GUIDE Plus+ setup menu
appears, it means that this recorder has
not been installed with the GUIDE Plus+
programme data yet. See pages 28~29 to
set-up the GUIDE Plus+ system.
C Use keys to select a desired TV
channel and use keys to select a
programme.
Press CH +/- to scroll down/up a
page at a time.
Press to go directly to a day
before or the next day TV listings.
D Press the Red button on the remote
control for .
E Press GUIDE to exit the menu.
To Next Page
Loading...
