EN 10
3139 785 31532
4.
Mechanical Instructions
4. Mechanical Instructions
Note: The position numbers given here refers to the
Exploded view on chapter 10.
4.1 Dismantling of the DVD Tray cover
1) Insert a screw-driver into the slot provided at the bottom
of the set and push in the direction as shown in
picture 4-1 to unlock before sliding the Tray cover
assembly out.
Figure 4-1: Remove DVDR tray
2) Remove the Tray cover assembly as shown in
Figure 4-2.
Figure 4-2: Remove tray cover assembly
4.2 Dismantling of the Front Panel assembly
1) Remove 7 screws to loosen Top cover.
2) Remove the DVD Tray cover as given in step 4-1.
3) Loosen the Digital Board & HDD as given in step 4-3.
4) Loosen 3 screws and 2 catches as shown in Figure 4-3
to separate the Front panel assembly from the Frame
assembly.
Figure 4-3
5) Remove 6 screws to loosen the Front plate to reach
the Front board service position (see Figure 4-4).
Figure 4-4: Front Board Service position
4.3 Dismantling of the Digital Board / HDD
1) Remove 4 screws to loosen the Digital Board as
shown in Figure 4-5.
Figure 4-5: Digital Board
1
2
To Next Page
Loading...
