- 5 -
Upgrade procedure –
Read this before you start
1 Press OPEN/CLOSE to open the tray.
2 Insert the upgrade CD-ROM disc, label side up.
3 Press OPEN/CLOSE to close the tray.
‰ First ‘READING’ appears on the display, followed by ‘DOWNLOAD’.
The upgrade procedure takes around 15 minutes in total.
‰ If the firmware was already updated, the display will show ‘UP TO DATE’ within
a few seconds. No upgrade is needed.
4 When the upgrade is completed the tray will open automatically.
‰ The display shows ‘REMOVE DISC’ or ‘TAKE DISC’.
5 Now remove the disc.
6 Press STANDBY/ON to switch off the recorder.
Note: If you have programmed any timers, check after finishing the upgrade procedure if they
are still correct and correct them manually if necessary.
- 5 -
English
To Next Page
Loading...
